(2) EIZO Corporation (hereinafter "EIZO") hereby informs you of the possibility of trouble occurring which might be caused by using the Software in combination with some operating software, applications or other computer environment you may use. The end user license agreement will be displayed at the time you start to download or install the Software. (1) The Driver Software or its utility which you, the end user, are going to download from this site and install (hereinafter the "Software") shall be used only on your own responsibility and before you use the Software, please read carefully the end user license agreement offered by the licensors. Good Luck.EIZO's End User License Agreement and support for the Software and limitation of liabilityĮnd user license agreement and Software operation confirmation ~/TouchKit/Guides/Driver Guide.pdf The guide is easy to understand and is much easier to accomplish than the driver installation. See the Driver Guide.pdf for information on this in the tar file we downloaded earlier. Now we have to setup X to load its driver so you can actually use the touchscreen. If you see this you got the driver installed properly, congrats. The thing to note is in the I: line shows Driver=TouchKit. I: If#= 0 Alt= 0 #EPs= 1 Cls=ff(vend.) Sub=ff Prot=ff Driver=TouchKit You should see something similar to below somewhere in there (I really should have looked into if this module would have worked properly)Īfter reboot check to be sure the touchscreen is detected and using the correct driver. We must blacklist the usbtouchscreen driver from loading. # This module may be renamed “usbtouchscreen”. Insert the following text into the /etc/rc.local file. Modify rc.local to load the module on bootup. Now copy the module to say /lib/modules and open /etc/rc.local for editing Make: Leaving directory `/usr/src/linux-source-2.6.18' You should see something similar to below KDIR := /lib/modules/$(shell uname -r)/build Tar -xjvf linux-source-2.6.18.tar.bz2 # Once again change to your kernel versionĬhange to your home directory and get the Touchkit driver You will need the following packages to successfully compile the module for the touchkit driver.Īpt-get install gcc linux-source-2.6.18 makeīe sure to change the linux source to the kernel you are using. You will need to be the root user for most of this guide. It has been tested on Debian Linux but other 2.6 kernel based distros should be fairly similar. This describes how to set up an eGalax touch screen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |